Notifications
Clear all

Chevrolet Malibu 2017 - 2019 SDM Airbag Module Location & Seat Belt Removal Instructions

 
Eli - MyAirbags Team
Estimable Member Admin

How to remove Chevy Malibu SDM airbag control module, also known as SDM Sensing Diagnostic Module

 

Vehicle in the video is Chevrolet Malibu 2017 - 2019

How to remove SDM airbag control module (sensing diagnostic module) & seat belt pretensioners on a

Chevy Malibu 2017, 2018, 2019

 

Where is the SDM Sensing Diagnostic Module, airbag control module located in my vehicle?

Click here for Airbag Module Location

 

IMPORTANT: Failure to follow instructions below may result in the accidental deployment of “airbag”, “seat belt”, which increases the risk of serious personal injury or death.

  • Never probe the electrical connectors on airbag or seat belt.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the airbag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

Steps to remove airbag control module

  1. First, find the SRS computer module. In most cars, it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat.
  2. Disconnect the positive battery cable and wait 3 min.
  3. You are now safe to unplug the airbag control module harness wiring plugs.

Steps to install airbag control module

  1. All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors.
  2. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
  3. Wait 3 minutes before installing the airbag module in the vehicle.
  4. Bolt down module with all bolts and then connect harness plugs. (if not then, could deploy roof airbags and seat belts)
  5. The vehicle needs to be flat on the ground. Not elevated on a jack or lift. (if not then, could deploy roof airbags and seat belts)
  6. Reconnect battery cables.

 

Image of Chevrolet Malibu SDM airbag control module

 
image
Quote
Topic starter Posted : 08/21/2021 12:40 am
Serge - MyAirbags Team
Noble Member Moderator
LOCATION CHEVY CHEVROLET MALIBU 2015 2016 2017 2018 2019 2020 AIRBAG SDM DERM AIRBAG CONTROL MODULE COMPUTER REMOVAL REMOVE INSTALL CENTER CONSOLE
ReplyQuote
Posted : 12/21/2021 4:42 pm
Share: