Notifications
Clear all
So I have a 2016 Chevy Silverado 2500 HDD and it was an accident I replaced the front impact sensors the driver side airbag the passenger side airbag the module and both pretensioners both pretensioners and I'm going to the program the module and I still have all these codes in here for pretty much everything I replaced for some reason and the module won't program for some reason any ideas ?
Topic starter
Posted : 12/13/2021 2:43 pm
If the airbag module was replaced will need to be programmed by the dealer or a local Body Shop that has programming equipment.
Please let me know if there is anything else I can assist you with.
Posted : 12/13/2021 2:43 pm
If the module is new there should be no issue programming the module to your truck. If the module is used and was installed in another vehicle before you installed it in your vehicle then the module would need to be wiped clean before it can be programmed to your truck. I'm guessing you have access to GDS-2. GM's format for programming.
Posted : 12/13/2021 2:44 pm
Do you have a GM subscription? If you don't, you will not be able to program the SDM
Posted : 12/13/2021 2:46 pm
Then unfortunately you will need to take to the dealer or a shop that can program GM vehicles.
Posted : 12/13/2021 2:47 pm
Yes I have a scan tool and everytime I go to program the new module it just says program unsuccessful I can't even clear the codes
Topic starter
Posted : 12/13/2021 5:11 pm
I have the ms909 by autel I would think it would be good to program it
Topic starter
Posted : 12/13/2021 6:40 pm
It's a new module
Topic starter
Posted : 12/13/2021 9:08 pm
I dont
Topic starter
Posted : 12/13/2021 10:37 pm